Removing and installing treble horn H2, bass horn H7 — VW
Removing and installing treble horn H2, bass horn H7 on VW: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Tighten securing bolt (1) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical consumers.
- Disengage ignition key out in position 0 (forward notch).
- Remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
- Release connector (2) and disconnect.
- Unscrew securing bolt (1) and remove signal horn (3) together with bracket.
- Install in the reverse order of removal. When doing this, note the following:
- Tighten securing bolt (1) to 20 Nm. — 20 Nm (15 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing side member trim, GTD – VW
- Removing and installing knee airbag with igniter – VW
- Removing and installing clutch pedal, Golf SV, Passat, Touran
- Removing and installing gear knob, Golf SV, Passat, Touran
- Removing and installing ATF cooler, Polo 2014 ►
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.