Removing and installing through-loading unit — VW

🧭 Before you start

Fits: platform codes A32, A33

• Renewed: if necessary

Don't miss

• Before installing, check all fasteners for damage and renew if necessary.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove 23 backrest cover and padding .
2. Remove centre armrest .
3. Fold through-loading unit (1) down in (direction of arrow) and remove it from backrest frame (2).
4. Remove trim (4) from backrest frame (3).
5. Unscrew bolts (5) (2 Nm) and remove retaining frame (2) from seat frame (3). [Note: Before installing, check all fasteners for damage and renew if necessary.] — 2 Nm (1.5 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking glow plugs – VW Sharan I / SEAT Alhambra · 7 torque figures
• Removing and installing timing chain and chain drive for oil pump (engine codes BAG, BLP, BLF) · 4 torque figures
• Removing and installing heater and air conditioning unit, as of WEEK 45/08 · 5 torque figures
• Repairing subframe, up to Week 26/2012 · 2 torque figures
• Checking ATF level – VW Sharan I / SEAT Alhambra · 5 torque figures