Removing and installing telephone bracket R126 — VW

🧭 Before you start

Fits: platform code 138

Don't miss

• When installing the wire, ensure it can move freely in order to avoid damage to the wiring harness.

📋 Procedure

1. Switch off ignition and all electrical consumers.
2. Remove ignition key.
3. Remove mobile phone from cradle.
4. Fold up centre console.
5. Remove bolts (arrows).

6. Remove trim at rear of centre console General body repairs, interior68Centre console; Removing and installing rear centre console trim.
7. Unclip connector upwards from retainer (arrow).
8. Disconnect connector in (direction of arrow).
9. Carefully unclip telephone bracket upwards (arrows).
10. Guide out wires upwards. [Note: When installing the wire, ensure it can move freely in order to avoid damage to the wiring harness.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Renewing sealing cap – VW Tiguan I
• Removing and installing gas discharge headlights with dynamic main beam regulation
• Removing and installing silencer, Tiguan
• Removing and installing exhaust gas temperature sender 4G648, CC
• Removing and installing starter, vehicles with 2.0 l TSI engine with 162 kW, manual gearbox MQ350