Removing and installing tail light (saloon 10.00 ▸): VW Passat B5
Step-by-step removing and installing tail light (saloon 10.00 ▸) for the VW Passat B5: 8 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B5 (3B)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 3 Nm (2.2 lb-ft) | Tighten securing nuts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical consumers and pull out ignition key.
- Fold trim in front of tail light in luggage compartment to side.
- Remove bulb holder .
- Unscrew securing nuts (arrows) and remove tail light housing.
- Insert tail light housing into body aperture.
- Tighten securing nuts (3 Nm). — 3 Nm (2.2 lb-ft)
- Install bulb holder and reconnect connector .
- Fold back trim in front of tail light in luggage compartment.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing turbocharger (engine codes CASA, CASB, CASC)
- Removing and installing lower part of left intake manifold (engine codes BKS, BUN)
- Removing and installing toothed belt for high-pressure pump (engine codes BKS, BUN)
- Removing and installing reduction agent supply line – VW CATA
- Removing and installing heater coolant shut-off valve N279 for vehicles with petrol engine · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.