TorqFix

Removing and installing tail light, saloon — VW

Removing and installing tail light, saloon on VW: 10 steps. What to remove, in what order, and what to check after.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

10 steps

🧭 Before you start

Fits: platform codes 602, 604, 612, 614, 642, 644

📋 Procedure

  1. Switch off ignition and all electrical loads, and pull out ignition key.
  2. Fold out opening in side luggage compartment trim.
  3. Unscrew securing element (1).
  4. Pull safety mechanism off connector (2) in direction of arrow.
  5. Push detent (3) and pull off connector from bulb carrier.
VW? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove left tail lightMX3 backwards out of side panel.
  2. Check installation position so that shut lines/gaps around tail light are even.
  3. Tighten securing element to specified torque .
  4. Securely engage connector and push safety mechanism into connector.
  5. Check functions of tail light.

Other VW procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.