Removing and installing supplementary heater bracket — VW
Removing and installing supplementary heater bracket on VW: 3 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)
Don't miss
- When installing bracket (1), observe centring tabs.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 0.8 Nm (0.6 lb-ft) | Unscrew bolts (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Removing auxiliary heater (see the separate procedure).
- Unscrew bolts (2) (8 ± 0.8 Nm) and remove bracket (1). — 0.8 Nm (0.6 lb-ft)
- Install in reverse order. [Note: When installing bracket (1), observe centring tabs.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing undamaged windscreen – VW
- Adjusting longitudinally – VW Passat CC / CC · 2 torque figures
- Removing and installing top ancillary bracket – VW 1.2 CBZA · 1 torque figures
- Removing and installing brake pads; Rear brakes, CI 38
- Removing and installing brake caliper; Rear brakes, Bosch ZOH BIR 38
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.