Removing and installing steering wheel, vehicles ▸ 05.00: VW Sharan I / SEAT Alhambra
Step-by-step removing and installing steering wheel, vehicles ▸ 05.00 for the VW Sharan I / SEAT Alhambra: 4 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan I / SEAT Alhambra (7M)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | Remove hexagon bolt and pull steering wheel off steering column |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove driver side airbag unit General body repairs, interior69Airbag.
- ⚠ Safety precautions when working on airbag. — Remove lower part of steering column switch trim .
- Pull foam tube off connector and separate connection.
- Remove hexagon bolt and pull steering wheel off steering column (hexagon bolt 40 Nm). — 40 Nm (30 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Adjusting wiper arms – VW Golf VII
- Removing and installing headlight main beam bulb M30/M32
- Removing and installing headlight range control motor V48/V49, headlights with H7 bulb
- Removing and installing headlight range control motor V48/V49, headlights with gas discharge bulb
- Removing and installing steering column switch base, Kostal
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.