Removing and installing steering column, removing and installing mounting bracket — VW

🧭 Before you start

Fits: VW Passat CC (357, 2008–2012), VW CC (358, 2012–2017)

Don't miss

• Bolts (arrows B) are screwed in from cross member.

📋 Procedure

1. Remove steering column .
2. Remove dash panel insert Electrical system90Dash panel insert; Removing and installing dash panel insert.
3. Unscrew bolt (arrow A).
4. Remove bolts (arrows B) from mounting bracket on body. [Note: Bolts (arrows B) are screwed in from cross member.]
5. Remove bolts (arrows) under mounting bracket.

6. Unscrew bolt (1) and remove mounting bracket from body.
7. Insert mounting bracket, screw bolts (arrows) and (1) in.
8. Install bolts (arrows B). [Note: Bolts (arrows B) are screwed in from cross member.]
9. Screw in bolt (arrow A).
10. Install steering column .
11. Install dash panel insert Electrical system90Dash panel insert; Removing and installing dash panel insert.
12. Carry out basic setting for steering angle sender G85 using .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking delivery pressure and tandem pump for leaks - engine codes BJB, BLS, BSU
• Emptying fuel tank, four-wheel drive, engine codes BJB, BLS, BSU
• Checking fuel delivery rate of fuel pump, vehicles with 6.0 bar low pressure fuel system
• Checking glow plugs Q10/Q13 – VW 1.9 TDI
• Removing and installing fuel tank, engine codes CAAA, CAAB, CAAC, CAAD, CAAE, CCHA, CCHB, CFCA