Removing and installing starterB, 5-cylinder petrol engine — VW

🧭 Before you start

Fits: platform codes 9C1, 1C1, 1Y7

📋 Procedure

1. RemovebatteryA.
2. Remove noise insulation with left side panel General body repairs, exterior50.
3. Remove bolts (1 to 5) and and take battery carrier off upwards.
4. Push protective cap back.
5. Disconnect connector (1) of terminal 50 on solenoid switch.

6. Remove nut (2) of wire for terminal 30.
7. Remove nut (3) for earth wire.
8. Remove bolt (arrow) from line clamp.
9. Remove nuts (1) and (2) from line clamps.
10. Remove nut (arrow) from starter bolt.
11. Pull the bracket downwards the bolt and lay to side.
12. Remove retaining bolts (arrows) from starterB.
13. Take starterB out upwards.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Assembly overview - cylinder bank 2 exhaust manifold with starter catalytic converters and attachments
• Removing crossmember for three-phase current drive VX54
• Removing and installing alternator C, 2.0 l, 147 kW petrol engine
• Removing and installing alternator C, 1.6 l, 77 kW diesel engine
• Removing and installing engine control unit J623 with protective housing, Eos