Removing and installing starterB, 3.6 l TSI engine, 220 kW, dual clutch gearbox DQ250-6F — VW
Removing and installing starterB, 3.6 l TSI engine, 220 kW, dual clutch gearbox DQ250-6F on VW: 19 steps.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)
Don't miss
- To avoid corrosion damage, do not loosen earth cable from earth point on body.
📋 Procedure
- Disconnect battery .
- Loosen spring-type clip (1) using spring-type clip pliersVAS 5024 A.
- Unfasten connector (2) and disconnect.
- Release locking lug (arrow) and remove cover in (direction of arrow).
- Release locking lugs (arrows) and pull air duct forwards in (direction of arrow) out of retainer.
- Unscrew securing bolt (arrow) of air filter housing.
- Pull air filter housing upwards out of rubber mountings
- and remove it from vehicle.
- Unbolt earth cable (arrow) from gearbox and lay to side. [Note: To avoid corrosion damage, do not loosen earth cable from earth point on body.]
- Unscrew securing bolts for air filter housing bracket (arrows)
- and remove air filter housing bracket from vehicle.
- Remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
- Unscrew lower securing bolt (arrow) for starter.
- Unfasten connector (1) and disconnect.
- Push protective cap (2) downwards off solenoid switch in (direction of arrow).
- Unscrew securing nut (arrow) and lay positive cable to side.
- Remove upper securing bolt of starter (arrow).
- Remove starter upwards from vehicle.
- Tighten threaded connections to torque specified in assembly overview .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Checking delivery pressure and tandem pump for leaks - engine codes BJB, BLS, BSU
- Emptying fuel tank, four-wheel drive, engine codes BJB, BLS, BSU
- Checking fuel delivery rate of fuel pump, vehicles with 6.0 bar low pressure fuel system
- Checking glow plugs Q10/Q13 – VW 1.9 TDI
- Removing and installing fuel tank, engine codes CAAA, CAAB, CAAC, CAAD, CAAE, CCHA, CCHB, CFCA
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.