Removing and installing starter, vehicles with manual gearbox MQ250 — VW
Removing and installing starter, vehicles with manual gearbox MQ250 on VW: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6R (2009–2014)
📋 Procedure
- Disconnect battery .
- Remove hose (2).
- Remove bolt (1) and release retaining lugs (arrows) to do this.
- Unlock connector (1) of terminal 50 and disconnect.
- Pull off plastic cap (2).
- Unscrew securing nut behind that and remove cable from solenoid switch terminal 30.
- Remove securing bolt (arrow).
- Unscrew nut from wiring retainer (arrow).
- Remove securing bolt (arrow).
- Remove starter downwards from vehicle.
- Tighten all threaded connections to specified torque .
- Connect battery .
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.