Removing and installing starter, 2.0 l petrol engine, 147 kW, manual gearbox — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

📋 Procedure

1. ⚠ When disconnecting or reconnecting the batteryA, adhere strictly to the procedure described in the workshop manual . — Disconnect batteryA.
2. Remove air filter housing 24Air filter; Removing and installing air filter housing.
3. Pull protective cap (1) off solenoid switch in (direction of arrow).
4. Release and detach connector (terminal 50) (1).
5. Remove nut (2) and remove positive wire (3) from solenoid switch.

6. Remove upper bolt (arrow) of starter.
7. Remove noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
8. Undo nut (1) and remove it from lower securing bolt of starter.
9. Remove wire holder (2).
10. Unscrew starter bolt (arrow).
11. Take starterB out downwards.
12. Tighten threaded connections to specified torque .
13. Reconnect batteryA.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing catalytic converters with front exhaust pipe
• Removing and installing hose connection with thermostat · 1 torque figures
• Removing and installing, dismantling and assembling pinion shaft
• Measuring and marking radial run-out on propshaft flange – VW · 1 torque figures
• Removing and installing starter, 4.9 litre 10-cylinder TDI engine, automatic gearbox