Removing and installing spray jet pop-up cylinders »Golf R« — VW

🧭 Before you start

Fits: VW Golf VI (5K, 2008–2013)

📋 Procedure

1. Switch off ignition and all electrical consumers and remove ignition key.
2. Pull spray jets together with cover cap (1) out of bumper cover to stop.
3. Unclip cover cap (1) from mounting points (arrows) on spray jet assembly.
4. Remove front bumper cover General body repairs, exterior63Front bumper.
5. Push down securing clip and pull hose connection (1) away from pop-up cylinder.

6. Unclip hose (3) from spray jet assembly (2).
7. Remove securing bolt (4).
8. Remove complete spray jet assembly (2) with pop-up cylinder from bumper cover.
9. Press both catches together simultaneously in direction of (arrow) and pull pop-up cylinder (2) downwards out of spray jet assembly (1).
10. Tighten all threaded connections to torques specified in assembly overview .
11. On completion of installation work, bleed headlight washer system .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing handle with holder (easy-entry) · 1 torque figures
• Removing and installing front airbag crash sensor, driver side G283 (USA) · 2 torque figures
• Removing and installing wheel housing trim for vehicles without side airbag · 2 torque figures
• Checking operation and power supply of fuel pump, vehicles with fuel pump control unit J538
• Installing side window with window regulator · 2 torque figures