Removing and installing spoiler, Polo »GTI« — VW
Removing and installing spoiler, Polo »GTI« on VW: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6C (2014–2017)
Don't miss
- Screw in bolts (5), but do not tighten them.
📋 Procedure
- Pull cover (1) with clips (2) out of roof spoiler (arrow a).
- Remove bolts (4).
- Pull roof spoiler (1) off rear lid (3).
- Clean area of bonding surface (7).
- Fit roof spoiler (1) on rear lid.
- Screw in bolts (5), but do not tighten them.
- Using removal aid (3), pull protective film off adhesive tape (4).
- Press on roof spoiler forcefully in area of adhesive tape (7).
- Tighten bolts (5).
- Push cover (1) with clips (2) into roof spoiler (arrow a).
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.