Removing and installing solenoids from tank shut-off valve 3N363 — VW
Removing and installing solenoids from tank shut-off valve 3N363 on VW: 5 steps, 1 torque figure, engines CDGA.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B6 (3C, 2005–2010), VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)
- Special tools named: T10522
🔧 Engine codes this applies to
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 130 Nm (96 lb-ft) | Tighten fuel tank shut-off valve |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📐 41 workshop diagrams for CDGA
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Remove fuel tank 3 .
- Unscrew plug (arrow) on fuel tank shut-off valve(1).
- Unscrew nut (arrow) on fuel tank shut-off valve(1) and remove it.
- Pull solenoid (2) in (direction of arrow) off fuel tank shut-off valve(1).
- Tighten fuel tank shut-off valve to 130 Nm using torque wrench VAS 6854 and wrench T10521/T10522. — 130 Nm (96 lb-ft)
Ask TorqFix about your VW CDGA — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your VW CDGA — free → or sign up free to see the drawingsOther VW procedures
- Checking and converting adapter for back pressure test on natural gas tank · 1 torque figures
- Removing and installing solenoids from tank shut-off valve 2N362 · 1 torque figures
- Removing and installing pulley – VW 1.4 CDGA · 1 torque figures
- Emptying fuel tank when fuel pump is intact, petrol
- Removing and installing regulating flap control unit J808 and throttle valve module J338
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.