Removing and installing sliding sunroof switch E8: VW Sharan I / SEAT Alhambra
Step-by-step removing and installing sliding sunroof switch E8 for the VW Sharan I / SEAT Alhambra: 6 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan I / SEAT Alhambra (7M)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Remove securing bolts (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off ignition and all electrical consumers and remove ignition key.
- Remove interior light .
- Pull off connector to interior light.
- Release fasteners on both sides of sliding sunroof switch (arrows) and take switch out of interior light.
- Insert switch in interior light and engage fasteners on sides.
- Reconnect connector and install interior light.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing screw-fixed retaining strips – VW · 1 torque figures
- Removing and installing front spoiler, GTI – VW Golf Cabriolet · 1 torque figures
- Removing and installing brake caliper, rear brake CII 41 – VW
- Removing bevel box, Passat 2011 ►, CC 2012 ► with 3.6 l - V6 petrol engine
- Removing and installing "“RCD 215”" · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.