Removing and installing sill panel moulding: VW Golf Sportsvan
Step-by-step removing and installing sill panel moulding for the VW Golf Sportsvan: 11 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf Sportsvan (AM1, 2014–2020)
- Renewed: if necessary
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Remove bolt (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove rear bench seat .
- Remove spreader clip (2).
- Remove clip (3).
- Unclip rear sill panel moulding (1) from wheel housing trim.
- Using wedge T10383, release rear sill panel moulding (1) from side member and beading of door seal (arrows).
- Remove rear sill panel moulding (1) from vehicle.
- Release rear sill panel moulding at transition to front sill panel moulding from body.
- Using wedge T10383, release locking lugs of front sill panel moulding (1) from lower B-pillar trim (2)(arrow A).
- Using wedge T10383, release front sill panel moulding (1) from side member and beading of door seal (arrows B).
- Open cover for belt guide and thread out seat belt.
- Remove sill panel moulding from vehicle. [Note: Before installing, check all fasteners for damage and renew if necessary.Remove any retaining clips left in body mountings using removal tool T40280 and fit them in sill panel moulding for installation.Following installation, ensure that the sill panel moulding is positioned in the door seal beading.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing brake system pressure accumulatorVX70, RHD vehicles
- Removing and installing selector mechanism without selector lever cable, Passat 2015 ►, Passat Variant 2015 ►
- Removing and installing high-voltage battery charging socket 1UX4, AC charging socket
- Removing and installing water radiator for charge air cooling circuit
- Removing and installing low-pressure turbocharger – VW CUAA
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.