Removing and installing securing brackets for centre console, front securing bracket — VW

🧭 Before you start

Fits: platform codes 5C7, 5C1

Don't miss

• Removal of front right securing bracket is identical.
• Before installing, all speed nuts (3) must be checked for damage. Damaged parts must be replaced.
• The footwell trim (1) must be correctly locked in position in the guides of the centre console (2).

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off ignition.
2. Undo and remove bolt (1) (1.5 Nm) and remove footwell trim (2). — 1.5 Nm (1.1 lb-ft)
3. Undo 2 nuts (2) (2.0 Nm) and remove securing bracket (1). [Note: Removal of front right securing bracket is identical.] — 2.0 Nm (1.5 lb-ft)
4. Install in reverse order of removal. When doing this, observe the following:
5. Before installing, all speed nuts (3) must be checked for damage. Damaged parts must be replaced.
6. The footwell trim (1) must be correctly locked in position in the guides of the centre console (2).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing rear side airbag crash sensor G256/G257
• Removing and installing luggage compartment side trim
• Removing and installing seat height adjustment, electrically adjustable front seat
• Removing and installing lock cylinder housing cap on front passenger side
• Removing and installing sliding sunroof seals on frame