Removing and installing rotary light switchEX1: VW Polo 6C

🧭 Before you start

Fits: VW Polo 6C (2014–2017)

Don't miss

• Turn rotary knob to "“0”" position in order to ensure that rotary light switchEX1 engages in dash panel.

📋 Procedure

1. Switch off ignition and all electrical consumers.
2. Remove ignition key.
3. Turn rotary light switchEX1 to "“0”" position.
4. Press in rotary knob of rotary light switchEX1(1) in opposite (direction of arrow A), and turn it in (direction of arrow B).
5. Hold rotary knob in this position.

6. Pull rotary light switchEX1(1) in (direction of arrow A) out of dash panel (2).
7. Disconnect connector (arrow A).
8. Remove rotary light switchEX1(1).
9. Connect connector to rotary light switchEX1.
10. Hold rotary light switchEX1, and press in rotary knob in (direction of arrow 1) while simultaneously turning it clockwise in (direction of arrow 2).
11. Hold rotary knob in this position.
12. Insert rotary light switchEX1 in (direction of arrow 3) in dash panel.
13. Turn rotary knob to "“0”" position in order to ensure that rotary light switchEX1 engages in dash panel.
14. Test functionality.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures