Removing and installing right exhaust manifold (bank 1): VW Touareg II (CJTA, CMKA, CMKB, CYJA)

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove right catalytic converter (bank 1) .
2. Remove air filter housing .
3. Remove lambda probe G39(arrow).
4. Unscrew bolts (1 ... 4) and remove heat shield.
5. Unscrew nuts (1) and (2) and remove heat shield bracket.

6. Unscrew nuts (1 ... 7) and remove exhaust manifold.
7. Fit exhaust manifold with gasket, coat threads of nuts with high-temperature paste and fit them.
8. Fit heat shield bracket with nuts (1) and (2).
9. Tighten nuts in the sequence (1 … 9) in 3 stages as follows:
10. Tighten nuts hand-tight.
11. Initially tighten to 15 Nm. — 15 Nm (11 lb-ft)
12. Tighten to 25 Nm. — 25 Nm (18 lb-ft)

Other VW procedures

• Securing engine on engine and gearbox supportVAS 6095 · 4 torque figures
• Removing and installing sender wheel · 4 torque figures
• Measuring radial clearance of conrods – VW Touareg II · 4 torque figures
• Removing camshaft adjuster – VW Touareg II 2.0 · 3 torque figures
• Renewing valve stem seals with cylinder head installed
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures