Removing and installing reversing light switch F4: VW Passat B5
Step-by-step removing and installing reversing light switch F4 for the VW Passat B5: 6 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B5 (3B)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 20 Nm (15 lb-ft) | Screw reversing light switch F4(arrow) into cover for selector shaft |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove noise insulation General body repairs, exterior50Noise insulation.
- Pull off connector (arrow) for reversing light switch F4 on right of gearbox.
- Unscrew reversing light switch F4(arrow) from cover for selector shaft.
- Screw reversing light switch F4(arrow) into cover for selector shaft to 20 Nm torque. — 20 Nm (15 lb-ft)
- Push on connector (arrow) for reversing light switch F4 on right of gearbox.
- Install noise insulation General body repairs, exterior50Noise insulation.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Partially dismantling and assembling gearbox, removing and installing 5th gear
- Removing and installing headliner
- Removing gearbox, Golf 2004 with 2.5 l - 110 kW and 125 kW engines
- 1.2 TDi CFWA Injector remove install
- Removing and installing dash panel insert – VW Passat B5 · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.