Removing and installing reversing light, from 07.05 — VW
Removing and installing reversing light, from 07.05 on VW: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 9C1, 1C1, 1Y7
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 4 Nm (3.0 lb-ft) | Tighten bolt |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Switch off ignition and all electrical consumersRemove the ignition key. — Insert a cross slotted screwdriver into the opening (arrow) and remove bolt.
- Unhook reversing light and take it out to rear.
- Disconnect connector (arrow) of reversing light.
- Tighten bolt to 4 Nm. — 4 Nm (3.0 lb-ft)
- Check function of reversing light.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing control unit and hydraulic unit, left-hand drive, diesel engine
- Removing and installing front exhaust pipe with catalytic converter
- Removing and installing starter (1.6 l, 1.8 l petrol engines and diesel engines) · 3 torque figures
- Adjusting turbocharger vacuum unit (engine codes BZB, CGYA, CDAA, CDAB) · 1 torque figures
- Adjusting turbocharger vacuum unit (engine code BYD) – VW BYD · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.