Removing and installing reservoir for windscreen and headlight washer system — VW
Removing and installing reservoir for windscreen and headlight washer system on VW: 13 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan I / SEAT Alhambra (7M)
Don't miss
- The elbow connections to the windscreen and rear window washer pump V59 are colour-coded and must be assigned to the correct connections on the windscreen and rear window washer pump V59 during assembly.
📋 Procedure
- Switch off ignition and all electrical consumers and remove ignition key.
- Remove front bumper General body repairs, exterior63Front bumper.
- Remove left headlight .
- Pull cover (1) off reservoir for windscreen and headlight washer system.
- Remove cover cap (2) from left headlight, if necessary.
- Remove bolt (3).
- Disconnect all connector (1) and open cable guide (2).
- If necessary, unclip hoses (3) from reservoir.
- Separate hose connectors (4) at windscreen and rear window washer pump V59 and headlight washer system pump V11. [Note: The elbow connections to the windscreen and rear window washer pump V59 are colour-coded and must be assigned to the correct connections on the windscreen and rear window washer pump V59 during assembly.]
- Drain any escaping fluid in a suitable container.
- Remove securing bolts (arrows) and remove reservoir.
- Tighten threaded connections to specified torques .
- On completion of installation work, bleed headlight washer system .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing pop-up cylinder
- Removing and installing gas discharge bulb L13/L14
- Removing and installing additional brake light bulb M25, Estate
- Removing and installing interior monitor send and receive module 1G303
- Removing and installing relay and fuse holder behind dash panel on driver side, on onboard supply control unit
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.