Removing and installing reservoir for windscreen — VW

🧭 Before you start

Fits: platform codes 6S1, 6S2

Don't miss

• The windscreen washer fluid level sender G33 is not fitted in all vehicles.

📋 Procedure

1. Remove front bumper cover General body repairs, exterior63Front bumper.
2. Unplug connector at windscreen washer fluid level sender G33(arrow). [Note: The windscreen washer fluid level sender G33 is not fitted in all vehicles.]
3. Unplug connectors at windscreen washer pump V59(arrow) .
4. Disconnect hose connections at windscreen and rear window washer pump V59(arrow). [Note: The connections at the pump and hoses are colour-coded to prevent incorrect connection of the washer fluid lines to the windscreen and rear window washer pump V59. The hose fittings must be connected to the correct colour-coded pump connections during installation.]
5. Drain any escaping fluid in a suitable container.

6. Remove securing nut (arrow).
7. Remove securing nut (arrow).
8. Remove securing nut (arrow).
9. Remove securing nut (arrow).
10. Take out reservoir for windscreen washer systems downwards.
11. Tighten all threaded connections to the specified torques .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing ATF cooler, rectangular design
• Removing and installing brake pads; Bosch ZOH BIR 38
• Removing and installing front inner door handle · 1 torque figures
• Removing and installing rear inner door handle · 1 torque figures
• Removing and installing middle deformation element · 1 torque figures