Removing and installing relay plate and 13-position relay carrier — VW
Removing and installing relay plate and 13-position relay carrier on VW: 6 steps, 1 torque figure. What to remove, what to tighten and to how many Nm.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf IV / Bora (1J)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 3 Nm (2.2 lb-ft) | Tighten nuts (C) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Disconnect battery .
- Carefully lever up the side dash panel cover.
- Remove trim under steering column General body repairs, interior68Compartments, covers and trim; Removing and installing trim under steering column.
- Remove securing screws (C).
- Release all wire connections (D).
- Lower relay plate (B) and relay carrier (A) to remove.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Renewing right seal on manual gearbox, between manual gearbox and bevel box or between manual gearbox and front differential lock
- Dismantling and assembling differential, front-wheel drive
- Removing and installing gear knob, CC
- Removing and installing selector cable, - gear lever is NOT "“pushed down”" to engage reverse gear
- Removing and installing windscreen wiper motorV
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.