Removing and installing reinforcing member »R«: VW Golf VI
Step-by-step removing and installing reinforcing member »R« for the VW Golf VI: 5 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf VI (5K, 2008–2013)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Tighten bolts, specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove lift cylinder for headlight washer system Vehicle electrics92Electrical system; Window washer/wiper system; Headlight washer system
- Unscrew bolts (2).
- Detach fasteners (arrows) of the reinforcing member (3) from the bumper cover (1).
- Press reinforcing member (3) into detents (arrows) of bumper cover (1).
- Tighten bolts, specified torque: 2 Nm — 2 Nm (1.5 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Installing gearbox, CC, vehicles with 1.4 l petrol engine, engine lifting eyes »at rear« of engine
- Installing gearbox, CC, Golf Cabriolet, vehicles with 1.4 l petrol engine, engine lifting eyes »at front« of engine
- Installing gearbox, CC with 1.8 l petrol engine
- Removing gearbox, Golf Cabriolet, vehicles with turbo diesel engine, engine lifting eyes »next to each other« on engine
- Installing gearbox, Golf Cabriolet, vehicles with turbo diesel engine, engine lifting eyes »next to each other« on engine
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.