Removing and installing rear lid, Saloon — VW

🧭 Before you start

Fits: platform codes AU1, BX5

Don't miss

• The connectors (4) for wires (2) are located on left C-pillars.
• Loosen bolts (5) on left and right hinges (do not unbolt completely).

📋 Procedure

1. Remove upper rear lid trim General body repairs, interior70Luggage compartment trims; Removing and installing rear lid trim.
2. Remove lower rear lid trim General body repairs, interior70Luggage compartment trims; Removing and installing lower rear lid trim.
3. Remove high-level brake light Electrical system94High-level brake light; Removing and installing high-level brake light.
4. Remove connectors of all installed electrical components.
5. Thread electric cables/wire together with rubber grommet (2) out of rear lid. [Note: The connectors (4) for wires (2) are located on left C-pillars.]

6. Loosen bolts (5) on left and right hinges (do not unbolt completely).
7. Remove gas struts (3).
8. Now, remove bolts (5) completely and then remove rear lid (1).
9. Install rear lid (1) with the aid of a 2nd mechanic.
10. Install gas struts (3).
11. Guide wires (2) into rear lid and attach rubber grommet.
12. Connect connectors of all installed electrical components.
13. Before closing rear lid, check function of release components.
14. Adjust rear lid .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing oil separator · 1 torque figures
• Removing and installing ignition coils with output stage · 1 torque figures
• Removing and installing voltage stabiliser J532, right-hand drive vehicles · 2 torque figures
• Removing and installing left cylinder head cover – VW · 1 torque figures
• Removing and installing right cylinder head cover – VW · 1 torque figures