Removing and installing rear interior lightWX2 — VW

🧭 Before you start

Fits: platform code BE1

Don't miss

• Electrical connector must face direction of travel.
• Press locking mechanism (1) in direction of arrow (C). Catches (2) must engage audibly.

📋 Procedure

1. ⚠ Danger of damage to component surfaces.When using leverage tools, mask visible areas of the component with commercially available adhesive tape. — Lever out lens (1) in direction of arrow (A) using, for example, a narrow screwdriver.
2. Remove lens (1) from rear interior lightWX2(2).
3. Release catches (2) in direction of arrow (A) using, for example, a narrow screwdriver.
4. Press locking mechanism (1) in direction of arrow (C).
5. Remove rear interior lightWX2(1) from roof aperture in direction of arrow (A).
6. Press connector lock in direction of arrow (B) and disconnect electrical connector (C). [Note: Electrical connector must face direction of travel.]
7. Press locking mechanism (1) in direction of arrow (C). Catches (2) must engage audibly.
8. Test functionality.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing emblems at vehicle front, Polo BlueMotion
• Removing and installing camshaft oil seal, exhaust camshaft, pulley end
• Removing and installing knock sensor – VW Polo 6C
• Removing and installing rear silencer, Golf, Golf Estate, Golf SV
• Removing and installing one-piece backrest cover and padding