Removing and installing rear belt buckle together with lap belt — VW
Removing and installing rear belt buckle together with lap belt on VW: 5 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 602, 642, 604, 644
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | Remove bolt (1 |
| 40 Nm (30 lb-ft) | Remove bolt (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove bench seat .
- Remove backrest .
- Remove bolt (1) (40 Nm). — 40 Nm (30 lb-ft)
- Remove belt buckle together with lap belt (3) from fastening buckle (2).
- Install in reverse order of removal.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing front upper transverse link – VW
- Removing and installing power-assisted steering rack, left-hand drive vehicle
- Removing and installing map-controlled engine cooling thermostat F265 · 1 torque figures
- Removing and installing fuel tanks 1 and 2, 7-seater, natural gas, engine code CDGA
- Adjusting multifunction switch · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.