Removing and installing radiator blind — VW

🧭 Before you start

Fits: VW Golf VII Variant (BA), VW Polo 6C (2014–2017), VW Golf Sportsvan (AM1, 2014–2020), VW Golf VII (5G, 2012–2020)

Don't miss

• Make sure that the guides of radiator blind (2) are properly seated on bumper carrier (1)(arrow).

🔧 Engine codes this applies to

📋 Procedure

1. Remove noise insulation 66Noise insulation; Removing and installing noise insulation.
2. Remove front bumper cover General body repairs, exterior63Front bumper; Removing and installing bumper cover.
3. Release and pull off connectors (2) and (3).
4. Unclip bracket (arrows) from front end (1).
5. Remove bolts (arrows).

6. Pull radiator blind (1) together with seal (2) towards front.
7. Secure radiator blind (1) to prevent it from falling.
8. Unclip seal (2) on retaining tabs (arrows).
9. Remove seal (2) from radiator blind (1).
10. Remove radiator blind (1) downwards.
11. Make sure that the guides of radiator blind (2) are properly seated on bumper carrier (1)(arrow).

Other VW procedures

• Removing and installing oil spray jets – VW Jetta VI
• Separating engine and gearbox, vehicles with dual clutch gearbox
• Removing and installing activated charcoal filter, hatchback
• Removing and installing charge pressure sender G31 / intake air temperature sender 2G299
• Removing and installing high-pressure pipe – VW Touareg II
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures