Removing and installing operating unit for window regulator in driver door E512 — VW

🧭 Before you start

Fits: VW Polo 6C (2014–2017)

📋 Procedure

1. Switch off ignition and all electrical consumers.
2. Remove ignition key.
3. Remove front left door trim General body repairs, interior70Front door trims; Removing and installing front door trim.
4. Disconnect connector from operating unit for window regulator in driver door E512.
5. Press fasteners on trim (1) for operating unit for window regulator in driver door E512 in (direction of arrow A).

6. Remove trim (1) for operating unit for window regulator in driver door E512 in (direction of arrow B) from door trim.
7. Release retaining hooks (3) on both sides of trim (1).
8. Remove operating unit for window regulator in driver door E512(2) from trim (1).
9. Engage trim for operating unit for window regulator in driver door E512 firmly in door trim.
10. Test functionality.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing exhaust gas recirculation cooler, “single turbo engine”
• Removing and installing curtain airbag with igniter, passenger compartment
• Removing and installing floor covering, Transporter
• Removing and installing curtain airbag in rear passenger compartment, Multivan
• Removing and installing speed sensor wire on front axle