Removing and installing operating and display unit, Climatronic — VW
Removing and installing operating and display unit, Climatronic on VW: 6 steps, 3 torque figures. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6C (2014–2017)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 0.2 Nm (0.1 lb-ft) | Unscrew bolts (2 |
| 1.5 Nm (1.1 lb-ft) | Remove bolts (2 |
| 1.5 Nm (1.1 lb-ft) | Remove bolts (arrows |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove trim for operating and display unit General body repairs, interior 68. Centre console; Removing and installing trim for operating and display unit.
- Unscrew bolts (1) (depending on respective vehicle).
- Remove centre console cover General body repairs, interior 68. Centre console; Removing and installing centre console cover.
- Disconnect connectors on operating and display unit for Climatronic air conditioning system E87(2).
- Remove operating and display unit for Climatronic air conditioning system E87 with Climatronic control unit J255 towards front.
- Install in reverse order of removal.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Renewing balancer shaft for exhaust camshaft
- Removing and installing fuel tank, four-wheel drive, engine codes BJB, BLS, BSU
- Removing and installing fuel hoses in engine compartment, 6.0 bar low pressure fuel system
- Checking delivery pressure of fuel system pressurisation pump G6, engine codes CAYD, CAYE, CFHC, CFHE, CFHF, CLCA, CFJA
- Removing and installing natural gas tanks 1 and 2
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.