Removing and installing oil pressure regulating valve N428 — VW

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

• Timing position: the crankshaft or camshaft is set and locked during this job
• Renewed: o-ring

🔧 Engine codes this applies to

📐 18 workshop diagrams for CASA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove front noise insulation (1)50.
2. Turn locking pins (arrows) 180° and pull out upwards.
3. Pull intake connecting pipe (A) out of the upper section of the air filter.
4. Open clips and remove upper part of air filter (B).
5. Remove filter elements.

6. Disconnect electrical connector (3) and remove bolt (1).
7. Release hose clips (2) and (5) and remove air pipes (left-side).
8. Disconnect electrical connector (1).
9. Remove bolt (2) and remove oil pressure control valve N428. [Note: Renew O-ring.]
10. Install upper part of air filter.
11. Install noise insulation 50.

Other VW procedures

• Removing and installing fuel pump G23, vehicles with 3.0 ltr. (V6) or 4.2 ltr. (V8) engine up to 05.2010
• Repairing diesel direct injection system
• Removing and installing pressure differential sender G505
• Checking fuel system pressurisation pump G6/fuel pump G23, vehicles with 6.0 ltr. (V12) engine
• Checking delivery rate of supplementary fuel pump V393
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures