Removing and installing mounting bracket, Golf Variant up to model year 2009, Jetta up to model year 2008 — VW

🧭 Before you start

Fits: VW Golf V / Jetta (1K, 2003–2009)

Don't miss

• Bolts (arrows B) are screwed in from cross member.

📋 Procedure

1. Remove steering column .
2. Remove dash panel insert Electrical system90Dash panel insert; Removing and installing dash panel insert.
3. Remove bolts (arrows) under bracket.
4. Push connector (1) in (direction of arrow) and remove from support in mounting bracket.
5. Unscrew bolt (arrow A).

6. Remove bolts (arrows B) securing bracket to body. [Note: Bolts (arrows B) are screwed in from cross member.]
7. Unscrew bolts (1) and (2) and remove mounting bracket from body.
8. Insert mounting bracket and screw in bolts (1) and (2).
9. Install bolts (arrows B). [Note: Bolts (arrows B) are screwed in from cross member.]
10. Screw in bolt (arrow A).
11. Insert connector (1) into support in mounting bracket and push to stop opposite (direction of arrow).
12. Install bolts (arrows) under bracket.
13. Install steering column .
14. Install dash panel insert Electrical system90Dash panel insert; Removing and installing dash panel insert.
15. Perform basic settings for steering angle sender G85 using vehicle diagnostic, testing and information systemVAS 5051B.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing connector – VW Touareg I
• Removing and installing upper part of intake manifold (engine codes CASA, CASB, CASC, CATA)
• Checking pressure retention valve in fuel return line – VW
• Removing and installing glow plugs, engine code CATA – VW CATA
• Checking valve timing (vehicles up to 11/2008) – VW Touareg I