Removing and installing mobile telephone operating electronics control unit J412, UMI control unit in centre console — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

📋 Procedure

1. Switch off ignition and all electrical loads, and pull out ignition key.
2. Remove devices connected to mobile telephone operating electronics control unit J412.
3. Remove trim at rear of centre console General body repairs, interior68Centre console; Removing and installing rear trim of »Comfort and Highline« centre console.
4. Remove trim bracket at rear of centre console General body repairs, interior68Centre console; Removing and installing rear trim bracket of »Comfort and Highline« centre console.
5. If fitted, remove rear air duct vent Heating, air conditioning87Air duct; Assembly overview - air duct and air distribution in passenger compartment.

6. Release catches (2) at bracket for mobile telephone operating electronics control unit J412(1).
7. Pull mobile telephone operating electronics control unit J412(1) with bracket and trim upwards out of centre console (arrow) until the connector is accessible.
8. Release and disconnect connector from mobile telephone operating electronics control unit J412.
9. Remove bolts (1).
10. Pull trim (2) in (direction of arrow A) off bracket (3).
11. Pull mobile telephone operating electronics control unit J412(4) in (direction of arrow B) out of bracket (3).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures