Removing and installing lower coolant pipes: VW 2.0 (CCZB)

🧭 Before you start

Fits: platform code 138

• Opens: coolant

Don't miss

• Secure all hose connections with the correct type of hose clips (same as original equipment) EKTA (Electronic Parts Catalogue).

🔧 Engine codes this applies to

📐 52 workshop diagrams for CCZB

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Drain coolant .
2. Remove air filter .
3. Loosen hose clip (2).
4. Remove bolt (4).
5. Disconnect electrical connector (arrow).

6. Remove bolt (1) and take out air pipe downwards.
7. Remove bolts (arrows) and detach electrical connectors (1 … 3) from retainer.
8. Move electrical wiring at small coolant pipe to one side (arrow).
9. Remove bolts (2 and 3).
10. Detach small coolant pipe from coolant pump and coolant hoses (1 and 4). [Note: Secure all hose connections with the correct type of hose clips (same as original equipment) EKTA (Electronic Parts Catalogue).]

Other VW procedures

• Checking fuel pressure sender G247 · 19 torque figures
• Assembly overview - cylinder head · 13 torque figures
• Assembly overview - timing chain covers · 12 torque figures
• Removing and installing ancillary bracket – VW Jetta VI · 10 torque figures
• Measuring radial clearance of crankshaft · 10 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures