Removing and installing knee airbag (Golf 2009 ►) — VW
Removing and installing knee airbag (Golf 2009 ►) on VW: 8 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf V / Jetta (1K, 2003–2009), VW Golf VI (5K, 2008–2013)
Don't miss
- The connector is located on the tunnel side (in the direction of travel).
- Ensure airbag connector engages audibly. — Switch ignition on.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 9 Nm (6.6 lb-ft) | Remove two nuts each (1) and (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Observe the general safety regulations when working on airbag, belt tensioner and battery isolator units (pyrotechnic components) — Switch ignition on.
- Disconnect vehicle battery Electrical system27Disconnecting and reconnecting battery.
- ⚠ Electrostatic discharges may result in unintentional triggering of airbag. Therefore, the mechanic must electrostatically discharge him/herself before disconnecting the igniter and earth wires. This can be done by briefly touching the body or striker plate of the door. — Disconnect connector from knee airbag. [Note: The connector is located on the tunnel side (in the direction of travel).]
- Remove two nuts each (1) and (3) (9 Nm). — 9 Nm (6.6 lb-ft)
- Remove knee airbag (2) from bracket (4).
- Install in reverse order of removal.
- ⚠ Ensure airbag connector engages audibly. — Switch ignition on.
- ⚠ Ensure that nobody is in vehicle. — Reconnect vehicle battery Electrical system27Disconnecting and reconnecting battery.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing bevel box, Golf 2004 ► and Passat 2006 ► with V6 engine
- Removing and installing fuel pressure regulating valve N 276
- Removing and installing high-voltage wiring harness for hybrid battery PX1
- Checking fuel pressure of supplementary fuel pump V393
- Assembly overview - multi-link rear suspension, rear brakes, Bosch ZOH BIR 38
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.