Removing and installing interior aerial 3 for entry and start authorisation R154 — VW

🧭 Before you start

Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Switch off ignition and all electrical consumers.
2. Disengage ignition key out in position 0 (forward notch).
3. Remove rear shelf General body repairs, interior70Trims, interior; Removing and installing rear shelf.
4. Remove pieces of insulation (1) and pull out spreader rivets (3).
5. Release connector (2) and disconnect.
6. Remove the interior aerial 3 for entry and start authorisation R154(4) from the rear shelf. [Note: The connecting wire of the interior aerial 3 for entry and start authorisation R154 of the flat wire is straight in delivery condition. Fold wire when connecting it, as shown in illustration enlargement.Place all insulation pieces back in their original position on rear shelf.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing upper bulkhead trim panel – VW · 1 torque figures
• Removing and installing bracket for trim of front backrest release mechanism · 1 torque figures
• Removing and installing locking mechanism – VW Golf Cabriolet · 1 torque figures
• Installing bevel box, 0AV
• Removing and installing gear oil pump – VW Jetta VI