Removing and installing impact damper: VW Jetta VI

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

• Renewed: if necessary

Don't miss

• Before installing, check all fasteners for damage and renew if necessary.

📋 Procedure

1. Disconnect battery earth cable with ignition switched on Electrical system27Battery; Connecting and disconnecting battery.
2. Removing dash panel .
3. Remove bolts (3).
4. Remove impact damper (2) from dash panel central tube (1).
5. Removing dash panel .

6. Remove bolts (1).
7. Remove impact damper (2) from dash panel.
8. Remove glove compartment .
9. Remove bolts (2).
10. Remove impact damper (1) from dash panel. [Note: Before installing, check all fasteners for damage and renew if necessary.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Installing 7-seater fixtures – VW Touran I · 1 torque figures
• Removing and installing control housing
• Removing gearbox, vehicles with 1.6 l/75 kW MPI engine – VW
• Removing and installing front door trim – VW · 3 torque figures
• Front seat belt (Saveiro "“single cab”" without pre-tensioner) - remove and install · 3 torque figures