Removing and installing ignition/starter switchD up to 10/2009 — VW

🧭 Before you start

Fits: VW Polo 6R (2009–2014)

Don't miss

• When installing the ignition/starter switch ensure that the ignition/starter switch and the lock cylinder are in the same position, e.g. "“ignition on”".

📋 Procedure

1. Disconnect battery .
2. Remove steering column switch .
3. Disconnect connector from ignition/starter switchD.
4. Remove anti-tamper paint from securing bolts (A).
5. Slightly loosen the 2 securing bolts (A) and pull ignition/starter switchD in (direction of arrow) out of steering lock housing.

6. ⚠ If improperly fitted, the ignition/starter switch as well as the lock cylinder will be damaged.Observe this fact, and ensure proper installation in order to avoid damage to the ignition/starter switch and the lock cylinder.Before inserting the ignition/starter switch into steering lock housing, ensure that the position of the ignition key in the lock cylinder matches the position of the ignition/starter switch. — Turn ignition key in lock cylinder until its position matches that of ignition/starter switch. [Note: When installing the ignition/starter switch ensure that the ignition/starter switch and the lock cylinder are in the same position, e.g. "“ignition on”".]
7. Push ignition/starter switch into steering lock housing.
8. Tighten securing bolts and reseal with anti-tamper paint.
9. Reconnect connector to ignition/starter switch.
10. Install all parts in reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures