TorqFix

Removing and installing hinges: VW Jetta VI

Step-by-step removing and installing hinges for the VW Jetta VI: 11 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

11 steps 1 torque figure torque figures merged from 13 documented variants

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

TorqueFastener / step
24 Nm (18 lb-ft)Specified torque for nuts (4

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

  1. If fitted, remove right and left hinge covers (1).
  2. To do this, release catches (2) on cover (1).
  3. Then, remove cover (1) in (direction of arrow) from hinge.
  4. Removing rear lid (1).
  5. Remove electric cable (5) from left hinge (6).
VW? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove gas strut (4) from ball-head pin at right hinge (2).
  2. Detach spring (3)(arrow) and remove from hinge.
  3. Remove rear shelf General body repairs, interior70Luggage compartment trims; Removing and installing rear shelf support.
  4. Remove bolts (7).
  5. Remove left hinge (2) or right hinge (6).
  6. Adjust rear lid .

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.