Removing and installing headliner storage compartment: VW CC

🧭 Before you start

Fits: VW CC (358, 2012–2017)

• Renewed: if necessary

Don't miss

• Before installing, check all fasteners for damage and renew if necessary.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove front interior light W1Electrical system96Lights and controls in headliner; Removing and installing front interior and reading light.
2. Release the two retainers (arrows) and pull out storage tray (1) from console.
3. Unscrew the two rear bolts (2) (1.2 Nm). — 1.2 Nm (0.9 lb-ft)
4. Unscrew the two front bolts (3) (1.6 Nm). — 1.6 Nm (1.2 lb-ft)
5. Pull out console (4) from reinforcement frame in moulded headliner (5).
6. Install in reverse order of removal. [Note: Before installing, check all fasteners for damage and renew if necessary.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing middle deformation element · 1 torque figures
• Removing and installing deformation element of C-pillar trim · 1 torque figures
• Removing and installing right trim on front passenger seat without height adjustment · 1 torque figures
• Removing and installing fire extinguisher holder – VW Jetta VI · 1 torque figures
• Removing and installing cover and padding for "“1/3”" bench seat