Removing and installing gas injectors: VW Polo 6R (CNKA)
Step-by-step removing and installing gas injectors for the VW Polo 6R (CNKA): 7 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Polo 6R (2009–2014)
🔧 Engine codes this applies to
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1 Nm (0.7 lb-ft) | Tighten bolts to 8 ± |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ There is a danger from escaping gas.The system is pressurised.Before opening the system place a cloth around the connection. Then release pressure by carefully loosening the connection.Wear suitable protection such as eye protection and protective gloves. — Carry out the following procedure:
- Detach connectors from gas injectors.
- Remove bolts (arrows).
- Take cover plate off and remove gas injectors.
- Refit cover plate.
- Tighten bolts to 8 ± 1 Nm. — 1 Nm (0.7 lb-ft)
- Reconnect connectors.
Other VW procedures
- Removing and installing crankshaft pulley · 2 torque figures
- Renewing paper filter on vaporiser – VW Polo 6R CNKA
- Removing and installing inlet valve – VW Golf VI · 1 torque figures
- Emptying the gas line
- Removing and installing gas rail sensor G401 – VW Polo 6R CNKA · 1 torque figures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.