Removing and installing "G93": VW Sharan I / SEAT Alhambra

🧭 Before you start

Fits: VW Sharan I / SEAT Alhambra (7M)

Don't miss

• Do not turn back gearbox before cover is reinstalled.Otherwise, clutch "“K2/K3”" and other components will fall out. — Remove cover.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove valve body .
2. Unbolt torque converter housing .
3. Remove bearing and differential cage.
4. Remove ATF strainer.
5. Turn gearbox.

6. ⚠ Do not turn back gearbox before cover is reinstalled.Otherwise, clutch "“K2/K3”" and other components will fall out. — Remove cover.
7. Remove sender "“G182”".
8. Unbolt wiring harness retainer.
9. Unbolt "“G93”" and remove.
10. Guide wire for sender "“G182”" from beneath through gearbox housing.
11. Push on connector, install sender "“G182”" and tighten bolts to 8 Nm. — 8 Nm (5.9 lb-ft)
12. Install cover.
13. Turn gearbox.
14. Install "“G93”" and tighten bolts to 8 Nm. — 8 Nm (5.9 lb-ft)
15. Push on connectors for "“G68”" and "“G265”".
16. Install wiring harness retainer and tighten bolt to 8 Nm. — 8 Nm (5.9 lb-ft)
17. Guide wiring into valve body housing.
18. Install ATF strainer.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures