Removing and installing fuel system diagnostic pump and activated charcoal filter — VW

🧭 Before you start

Fits: VW Golf IV / Bora (1J)

🔧 Engine codes this applies to

📐 25 workshop diagrams for AQP

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Raise vehicle.
2. Remove rear right wheel.
3. Remove rear right wheel housing liner General body repairs, exterior66Removing and installing wheel housing liner; Rear wheel housing liner.
4. Unbolt cover plate in front of tank filler neck.
5. Detach connector (1) from fuel system diagnostic pump V144 and disconnect breather line (2) at connection.

6. Then clip breather line to activated charcoal filter solenoid valve 1N80(3) in wheel housing and unplug connection.
7. You can now unscrew securing nuts (4) and remove fuel system diagnostic pump V144.
8. Remove silencer .
9. Then unscrew heat shield over rear silencer from floor panel.
10. Next unscrew right and left anti-roll bar bearings from underbody. Running gear, axles, steering, front- and four-wheel drive42Assembly overview for subframe with final drive
11. Unscrew cover beneath activated charcoal filter.
12. Detach connector (1) from activated charcoal filter solenoid valve 2N115.
13. Unscrew three studs (arrows) and remove activated charcoal filter from well.
14. Installation of activated charcoal filter is carried out in reverse order.

Other VW procedures

• Checking non-return valve for fuel pump
• Removing and installing fuel gauge sender – VW Golf V / Jetta
• Checking oil pressure switch – VW Golf IV / Bora
• Removing and installing parts of lubrication system
• Part I: chain drive - engine codes AQP and AUE - assembly overview
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures