Removing and installing front wheel housing liner — VW
Removing and installing front wheel housing liner on VW: 10 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 121, BL1
- Renewed: if necessary
Don't miss
- Check spreader nuts for damage and renew if necessary.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Tighten wheel housing liner bolts (1) through (11) in sequence given to specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove wheel Running gear, axles, steering44Wheels, tyres; Specified torque for wheel bolts.
- Pull out spreader rivet (3).
- Remove bolts (1).
- Pull wheel housing liner (2) out of wing. [Note: Check spreader nuts for damage and renew if necessary.]
- Insert front wheel housing liner (1) into wing.
- Align front wheel housing liner (1) with front bumper cover.
- Insert spreader rivet (3).
- Start all bolts and tighten them in sequence described below .
- Tighten wheel housing liner bolts (1) through (11) in sequence given to specified torque of 2 Nm. — 2 Nm (1.5 lb-ft)
- Install wheel Running gear, axles, steering44Wheels, tyres; Specified torque for wheel bolts.
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.