Removing and installing front wheel covers: VW Passat B8
Step-by-step removing and installing front wheel covers for the VW Passat B8: 14 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B8 (3G, 2014–)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Tighten bolts (5) to specified torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Unscrew bolts (3) in wheel housing.
- Warm front wheel arch trim (1) using hot air blowerV.A.G 1416.
- Pull off front wheel arch trim (1) starting at side member (arrow a).
- If wheel arch trim cannot be lifted off, use cutting cord to cut through adhesive tape (5).
- Pull out wheel arch trim from below trim on bumper cover (2)(arrow b).
- Prepare wheel housing (1) for bonding .
- Clean bonding surface (5).
- Apply 2-pack adhesive between adhesive tape (5), width = 6 mm, height = 10 mm.
- Guide front wheel arch trim (1) under trim on bumper cover (arrow a).
- Engage wheel arch trim in wing and side member extension (4)(arrows c).
- Fit trim to wheel housing and pull off protective backing using removal aids (6)(arrow b).
- Press on front wheel arch trim firmly in area of adhesive tapes (2).
- Tighten bolts (5) to specified torque of 2 Nm. — 2 Nm (1.5 lb-ft)
- Minimum curing period .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing front treble loudspeakers R22/R20 · 1 torque figures
- Removing and installing brake pedal, RHD
- Checking fuel pressure during vehicle operation, engine codes CCZB, CDAA, CDAB
- Removing and installing fuel filter, engine codes CUVC, CUWA
- Removing and installing engine bracket, Touran
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.