TorqFix

Removing and installing front seat fan V268, Passat CC 2009► and CC 2010► — VW

Removing and installing front seat fan V268, Passat CC 2009► and CC 2010► on VW: factory workshop procedure. Full factory text, tools and checks.

Workshop procedure for VW — the factory write-up, straight from real workshop data.

factory workshop text

📋 Procedure

Removing and installing
front seat fan
V268
, Passat CC 2009► and CC 2010►
Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate.
For vehicles which are initially registered in the USA, observe
“safety precautions when working on seat occupied recognition”
when working on the
front seat fan
V268
(front passenger seat)
Chapter
.
For vehicles which are initially registered in the USA apply the same instructions for removal and installation of the
front seat fan
V268
(front passenger seat) as appropriate in the following description.
Removing
WARNING
Observe the general safety regulations when working on airbag, belt tensioner and battery isolator units (pyrotechnic components)
Chapter
Attach
seat repair stand
VAS 6136
to
engine and gearbox support
VAS 6095
.
Remove front seat
Chapter
.
Secure seat to
seat repair stand
VAS 6136
.
Remove front belt buckle
Chapter
.
Remove seat cover cap
Chapter
.
Seat, electric
Remove trim from front of (electric) seat
Chapter
.
Remove (electric) seat trims
Chapter
Remove (electric) seat trim holders
Chapter
.
Seat, part electric
Remove (part electric) seat trim
Chapter
Remove seat trim holder and operating lever (part electric/height adjustable)
Chapter
.
Height adjustable seat
Remove (height adjustable) seat trim
Chapter
.
Remove seat trim holder and operating lever (part electric/height adjustable)
Chapter
.
Front passenger seat with through-loading aperture
Remove seat trims
Chapter
.
Remove seat trim holder and operating lever (part electric/height adjustable)
Chapter
.
Seat without height adjustment
Remove seat trim (seat without height adjustment)
Chapter
.
Remove seat trim holder (without height adjustment)
Chapter
All seats
Remove front seat backrest
Chapter
.
Remove padding of front seat cushion
Chapter
.
Note
Removal of the cover is not necessary.
Cut bonded felt
1
in area of
front seat fan
V268
2
and pull off padding
3
.
Remove
front seat fan
V268
from padding.
Installing
Insert
front seat fan
V268
2
in respective opening of padding
1
.
Pull protective backing off felt
1
and bond felt onto padding
3
without creasing.
Further installation is performed in the reverse order of removal.

Is this your exact engine?

TorqFix answers live for your specific car — tell it the engine code and it serves the matching sequence, torque figures and wiring for that exact variant.

Ask about my car →

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.