Removing and installing front seat backrest fan V269 — VW

🧭 Before you start

Fits: VW Passat B7 saloon (362, 2010–2014), VW Passat B7 Variant (365, 2010–2014)

📋 Procedure

1. ⚠ Observe the general safety regulations when working on airbag, belt tensioner and battery isolator units (pyrotechnic components) — Attach seat repair standVAS 6136 to engine and gearbox supportVAS 6095.
2. Remove front seat .
3. Secure seat to seat repair standVAS 6136.
4. Remove front belt buckle .
5. Remove trim on tunnel side

6. Remove trim of (electric) seat
7. Remove (partially electric) seat trim
8. Remove (height adjustable) seat trim .
9. Remove front seat backrest .
10. Secure backrest to seat repair standVAS 6136.
11. Remove head restraint .
12. Remove cover and padding from front seat backrest .
13. Cut bonded felt (3) in area of front seat backrest fan V269(2) and remove from padding (1).
14. Remove front seat backrest fan V269 from padding.
15. Insert front seat backrest fan V269(2) in respective opening of padding (1).
16. Pull protective backing off felt (3) and bond felt onto padding (3) without creasing it.
17. Further installation is performed in the reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Renewing oil seal for right flange shaft, four-wheel drive · 2 torque figures
• Removing gearbox; Golf Cabriolet 2012 ► 1,4 l - 92 and 110 kW petrol engine, engine lifting eyes »at front« of engine
• Removing and installing camshaft control valve – VW 3.6 · 2 torque figures
• Removing and installing washer fluid reservoir (vehicles with no auxiliary heater) · 3 torque figures
• Removing and installing door trim · 3 torque figures