Removing and installing flame monitor G64: VW Touareg II
Step-by-step removing and installing flame monitor G64 for the VW Touareg II: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
Don't miss
- The burrless side of the graphite seal (2) must face the collar of flame monitor G64(1).
📋 Procedure
- Switch off ignition (and auxiliary heating).
- Remove auxiliary/supplementary heater .
- Dismantle auxiliary heater .
- Heed the safety precautions Safety instructions.
- Also comply with general notes General notes.
- Observe repair instructions Repair notes.
- Pull flame monitor G64(1) out using commercially available cable tie.
- Eject (black) wires of flame monitor G64 from chambers 1 and 2 of 14-pin connector.
- Fit new graphite seal (2) on flame monitor G64(1). [Note: The burrless side of the graphite seal (2) must face the collar of flame monitor G64(1).]
- Insert flame monitor G64 in groove (3).
- Press graphite seal in direction of (arrow) using screwdriver.
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.